Engineering Drawing and Computer Aided Drafting, 2e (JNTU H) (R25)

Unit-I: Introduction to Engineering Graphics

1. Introduction to Engineering Graphics
2. Scales
3. Plane Curves in Engineering Graphics

Unit-II: Orthographic Projections

4. Projections of Points
5. Projections of Straight Lines
6. Projections of Planes
7. Auxiliary Projections

Unit-III: Projections of Regular Solids

8. Projections of Solids
9. Sections and Sectional Views of Solids

Unit-IV: Development of Surfaces of Right Regular Solids

10. Development of Surfaces of Solids

Unit-V: Isometric Projections

11. Isometric Projection
12. Orthographic Projections
13. Introduction to Computer Aided Drafting and Modeling
14. Computer Aided Drafting using AutoCAD

• Appendix I: Multiple Choice Questions (MCQs)
• Appendix II: Conversion of Pictorial View into Orthographic Views